Some newbie questions - Capture - Forum - Community Support

Saitec

New Member

Posts: 0

1/2/2009 8:25 PM

Hi ,

I've downloaded the demo of Capture Polar and ETC SmartSoft. I have added a Generic PAR 64. But when I set intensity in SmartSoft to 100% I get a light point on the floor, but not the beam.. how can I make the beam visible?

And can anybody explain me how to make a show in SmartSoft? I made memories, but how can I play them? And how play it to music ..

I hope anybody can help me

Regards,

Lars Wernlund

Staff Member

Posts: 2165

1/3/2009 11:13 AM

Hi Saitec,

I think you're looking for the "Atmosphere" setting of the view that you have in live mode. In the (bottom right) "project window", locate the view in tree on the left half and you should find this propery on the right hand side!

As for SmartSoft operation, I recommend reading the SmartSoft manual or visiting the ETC forums at etcconnect.com !

Regards,
Lars Wernlundn

Saitec

New Member

Posts: 0

1/3/2009 5:38 PM

thanks a lot. thats exactly what I searched :)

Regards,

Saitec

New Member

Posts: 0

1/4/2009 12:16 AM

me again,

is it possible to control the atmosphere for each light single? because when I set atmosphere to 50% some lights have to much beam, others have nothing..

Regards,

Lars Wernlund

Staff Member

Posts: 2165

1/9/2009 7:28 AM

Hi saitec,

No, atmosphere levels cannot be controlled per-fixture. Differences are derived from library data about fixture intensities. If you suspect that a fixture behaves incorrectly, please send an e-mail to library@capturesweden.com reporting the fixture that you believe has incorrect brightness data!

Regards,
Lars Wernlund