Forum

Ive updatet Hog4Pc to version 3.2 and also the Hog4 Connectivity Driver to version 3.2 . Now the Hog4 Connectivity Driver wont open when the Capture window is loading. Did anyone else here noticed this problem Capture version is 21.0.12

Here's a slight difficulty I've come across. I built a rig, and then found out that all the fixtures needed to be rotated by 180 degrees. 'No problem' I thought, 'I'll just select them all and type in '180' into the Y rotation field. Except it seems that Capture will only accept values up to 90º, after that, it 'starts over' again, so a rotation value of 180º gives the same result as a value of 0º. The only way around this that I've found is to individually zoom in, individually select each fix...

Hi! I see that the ETC ColorSource PAR is available but not the ColorSource Spot - was wondering if that might be able to be added ASAP https://www.etcconnect.co...olorSource/Spot.aspx Thanks! Mike

Fixture Request - ETC Source Four Mini