HELLO I HAVE BEEN USING CAPTURE FOR OVER A MONTH AND I NOTICED THAT THE COORDINATES ENTERED FOR AND OBJECT RESPONDS TO ITS REAL CENTRE I WAS WONDERING IF AN OPTION CAN BE ADDED FOR THE COORDINATES TO BE THE END OF THE BJECT OR THE START OF IT NOT ONLY THE CENTRE FOR EXAMPLE A LED SCREEN 1 METER HEIGHT IF I ENTER Y:0 HAL OF IT WILL BE UNDER GROUND....
The position of the object should be it's clamp.
This does not apply to screens or curtains (or other objects other then fixtures). It would be great if as a general guide the bottom of objects keep their distance to the floor when resized unless they where snapped to another object, then to top of the object should stay at the heigth of the point to which it snapped on insertion.
Form objects (like Boxes, Curtains, etc.) should never end up half way below Y=0 on insertion.
When combined the two rules above should result in less actions on inserting and resizing an object.
Try with inserting a 'stage' (box) of 15 meters wide, 10 meters deep and 80cm high on floor (Y=0) level.