I'm working with the Eurolite LED Super Strobe ABL.

In all channel modes, adding colour and intesity works fine (that's to say when the light is static and no strobe effects are applied.)

When used in modes with only a strobe speed channel and no flash duration channel (that's 7-channel and 148-channel modes), when the strobe speed channel is used, the strobe cuts out in Capture. From values 000 - 008 nothing happens and the light is static (as should be), but from values 009 - 225 in which the strobe effect should activate and vary in speed from 0% - 100% throughout values 009 - 225, the light cuts out, turns dark and nothing is shown. I want to be able to see the strobe effect in this case, on channel modes with only intensity and flash speed channels and no flash duration channel.

When used in 13-channel and 22-channel the RGB LEDs can be controlled with a flash duration channel, and that works fine and as expected. Still, the white LEDs do not have a flash duration channel in any mode and therefore fail with the afore mentioned problem. 

I have checked patch + DMX etc., and have tested simply changing channel values in Capture with no succes.

When I control the physical fixture it works as it should in all channels, therefore I'm certain it's an issue with Capture.

Has anyone else had this problem, and is there a known solution?

Thanks in advance.