Forum

Hi there, Is it possible to get snow or rain inside a render

Hi Capture, Would it be possible to add our own fixtures to the libary, and what would be the rightfull steps We already have a 3d model and patchlists from our fixtures. Hope we could make it work! We currently have 3 fixtures of our own, 2 strobos and 1 kind of pixel bar. Thankyou

Hi, Please excuse the lack of searching if this has been asked before. I have a few fixtures that won't be included in my paper plot, how do I stop them being counted in the fixture key Thanks.

Hi. I´m wondering if there is a way to export the view of the heat map in some way, or is the only way to do that just plain screen capture

Just wondering a few things: Why is the symbol for a gobo rotator like a big tube that gets stuck on the end of a fixture Can an I-Cue be attached to the same fixture as a rotator Will or can there be a accesory available iin the library that will be a more accurate representation of a rotator (we are using Apollo rotators, which are not-yet-in the library) I ask because I work with a lot of community groups that use a source 4 with, actually, up to three accessories: The rotator, an I-Cue...

Hello!  How do you add Christmas light strands to a design I searched the forums and found a post from 2009 saying they were working on adding bulbs and christmas lights. Have they made that work yet Chris

Hi all, Can somebody explain me how to patch the camera via MagicQ (or maby there is better way) to control it and make a simply project presentation I can easly patch the lighting units and control it via MagicQ but the camera patch is not working or Im doing something wrong Regards, Karol

Hi all, I was wondering something about the rigging point item. Is this item to be used as a way to show the riggers were the rigging points are, or can they be used to calculate the weight on that point in a truss or pipe There is a weight option in the properties tab of the rigging point, but default it is set to zero and you can enter a weight manually. Can you attach a rigging point to a truss or pipe in a way that it shows how much weight there is on that point on a truss Thanks ...

Hello and good evening my question is how do i print only 1 layer from the project my middle truss covers the lamps on the ground so i want to print these two layers separately can someone help Thanks

Hi  Just started using capture and loving the program so far  I would like to Add the weights of truss lines to my plot view for sedning out to venues  Is this possible  Thanks  Ed